|Edge and Wax
|Full Tune (Stone Grind + Edge & Wax)
|Full Tune with Fills
|Ski Binding Mount (Free with purchase)
|Snowboard Binding Mount
• Additional charges may be applied for edges and bases with excessive rust/damage.
• All other repairs and boot adjustments will be quoted upon inspection.
• Please remove your snowboard bindings if requiring an edge or full tune.
• Please allow 7 days for turnaround on tunes. Same day waxing may be possible though not guaranteed.
Gold Coast Store
• Waxing available in store.
• Drop off and pick up available for other services. Please allow longer for turn around due to transport times.
Our Brisbane store is fully equipped with Wintersteiger Machines.
Our technicians can tune and service your skis or board to make them look like
new again. Drop into the store and we will advise on the work we think is required. If the Gold Coast store is more convenient then similar advice can be given there.
Waxing your skis is required to protect them and keep them performing at
their potential. Waxing is required after base repair and edge work, as well as throughout their use, to ensure your base glides smoothly. Waxing every three or four outings is a good practice.
Storage wax should be applied between seasons. This will stop your base from drying out and help protect your edges from rusting. This wax will also be drawn deeper into the base, leading to better and longer lasting glide upon their subsequent use.
Proper tuning of your skis and snowboards will prolong the life of your
equipment. Tuning your equipment will ensure it runs true, flat and catch free.
Skis and Snowboards will glide faster and initiate turns quicker when correctly
tuned and waxed.
Tuning your skis & snowboard involves three primary steps:
• Base repair
• Edge work
How do you know if you need to tune your skis? First, look at the base for
scrapes, exposed holes into the core, no structure, blunt/rusted edges, no wax
etc. If this is the case you need a tune and or a wax.
Everyone gets some base damage at some point, usually from skiing/riding
over a rock that’s not covered by enough snow. A gash in your base affects
how well your skis/snowboard glides, so it’s important to repair the damage.
Our modern Wintersteiger stone grinder will give your ride a perfectly flat and
structured base for the snow conditions wherever you’re headed.
Rust and burrs on your ski edges cause drag and slow you down on firm snow;
so, getting rid of these abrasions can help your skis and boards perform to their
Our Wintersteiger ceramic edger will grind the perfect base and side edge angles, leaving a clean micro-serrated edge that is sharper and harder wearing
than a traditionally sharpened edge.
167 Elizabeth Street
Brisbane QLD 4000
(07) 3229 8911
Gold Coast Snowbiz
2 Nerang St
Southport QLD 4215
(07) 5531 3035
Don’t know how to set up your Snowboard?
Let us talk you through it. Bring in your gear and we can set it all up for you,
find out if you’re natural or goofy, make sure the angles are correct and the
bindings are on safe and securely.
Got Problems with your Boots?
We are fully equipped to stretch boot shells, heat-mold liners, construct custom
foot-beds and add padding where you need it most. This is a service we offer
free when purchasing boots off us or already purchased in the past.